Living in Valencia, with summer just around the corner, the sight of that murky green pool in my yard was a real headache. I didn’t maintain it much last winter, and it had become an eyesore. Last weekend, I finally decided to change all the water. The whole process was quite a hassle, but I gained a lot of experience, which I’m sharing with fellow pool owners on this forum to help you avoid the same mistakes.
Should You Do a Complete Water Change?
Many people’s first instinct upon seeing green water is to drain it all and start over, but that’s not always necessary. In most cases, a “shock treatment” combined with circulation and filtering can bring it back. I asked my neighbor, and he mentioned that a complete water change every 3-5 years is generally sufficient. You should only consider a full change under these circumstances:
- The Total Dissolved Solids (TDS)
level is too high, rendering chemical treatments ineffective.
- The pool has been neglected for a long time, and the water has severely deteriorated with significant algae and sediment.
- You need to perform major repairs or repaint the pool’s interior walls.
My situation was the second case, and since there were some small cracks on the pool walls I wanted to patch up anyway, I decided to do it all in one go.

DIY vs. Hiring a Professional Company
This is the key question. I was on the fence for a long time and even called a few ‘Jardinería’ (gardening) and specialized pool maintenance companies. Here’s a simple comparison I put together for your reference:
| Comparison | DIY | Hire a Professional Company |
| Cost | Lower, mainly water and electricity bills | Higher, includes labor and equipment fees |
| Time | Time-consuming, can take 2-3 days depending on pool size | Efficient, usually done within a day |
| Expertise | Requires self-learning, risk of improper operation | Professional equipment and chemicals, guaranteed results |
| Convenience | A lot of hassle, especially cleaning the sludge at the bottom | Completely hands-off, saving you time and effort |
I ultimately chose the DIY route, mainly to save some money and for the experience. It turns out, you really can save several hundred euros, but the physical effort is immense. If you have a very large pool or just don’t want the trouble, I’d still recommend hiring someone.
Simple Steps for a DIY Water Change
If you’re determined like me and decide to tackle it yourself for your villa swimming pool, the process is roughly as follows:
- Pumping out the water: Use a submersible pump to drain the old water. Be careful not to drain it directly into your garden, as it could flood. It’s best to direct it to the designated municipal sewer. As the water level gets low, you’ll find a lot of dirt at the bottom. This is the most exhausting part, requiring a brush and bucket to clean it out.
- Cleaning and Repairing: Once the pool is empty, use a pressure washer and special pool cleaner to scrub the walls and floor. This is a good time to check for any loose tiles or cracks and patch them up with special waterproof putty.
- Refilling: After cleaning, you can start refilling. The water bill here isn’t cheap; for my 40-cubic-meter pool, the water alone cost over a hundred euros. When refilling, you can fill a small amount first to check for any leaks.
- Water Treatment: This is the most crucial step! Once the new water is in, it’s just “clean” water, not yet “healthy” pool water. You need to perform an initial chlorination (shock treatment) and adjust the pH level immediately. It’s best to do this within 24 hours of finishing the refill, and then run the filtration system for at least 8-12 hours.
After all that, despite the aching back, the sense of accomplishment seeing the crystal-clear blue water is unparalleled! It feels like my sunshine and beers for this summer are all sorted
! I hope my little experience helps you all. Experienced folks are also welcome to share their tips and add to the discussion!